Icom IC-F7010 Series Operating Manual

Contents

Icom IC-F7010 Series Operating Manual Manual pdf 11 page image

2 PANEL DESCRIPTION2-3Function display (for the Portable type transceiver)D Icon AreaIndicatorsq SIGNAL STRENGTH INDICATORDisplays the relative receive signal strength level.w CLOCKDisplays the current time.L “AM” or “PM” is displayed beside the time display whenthe 12 hour display format is selected.L “--:--” is displayed instead of the current time when theinternal clock is not set.e BATTERY INDICATORDisplayed or blinks to indicate the battery status.IndicationBatterystatus Full Mid ChargingrequiredBatteryexhaustedblinks when the battery is exhausted.IconsThe following icons are displayed in the Icon Area.POWER ICON• “L1” is displayed when the output power is set to Low.• “L2” is displayed when the output power is set to Mid.• “H” is displayed when the output power is set to High.AUDIBLE ICONDisplayed when the channel is in the ‘audible’(unmute) mode.MESSAGE ICON• Blinks after Messages (Message or Status Message)have been received.• Stops blinking when the screen is changed, or anykey is pushed, but is displayed if unread messagesare still in the Message memory.• Disappears when all messages in the Messagememory have been read.NOTE: The screen capture is an example. Thedisplayed position of each icon may differ, dependingon the function being used.Icon Areaq weBELL ICONDisplayed when a matching signal is received,depending on the presetting.SCAN ICON• Displayed when a scan is paused.• Blinks while scanning.SCAN TARGET CHANNEL ICONDisplayed when the channel is selected as a scantarget channel.SCRAMBLER/ENCRYPTION ICONIn the Analog modeDisplayed when the Voice Scrambler function is ON.In the Digital mode• Displayed when the Voice Encryption function is ON.• Blinks when decoding an encrypted signal.GPS ICON• Displayed when valid position data is received.• Blinks when searching for satellites or calculatingposition data.L Depending on the presetting, the GPS icon is not displayed.RECORD ICON• Displayed when the Record function is ON.• Blinks while recording audio.L “ ” is displayed when there is no microSD card freespace and audio cannot be recorded.TALK AROUND ICONDisplayed when the Talk Around function is ON.PHONE ICON• Displayed when the transceiver is connected to atelephone network on the selected channel.• Blinks while receiving a phone call.SITE LOCK ICONDisplayed when the Site Lock function is ON.LONE WORKER ICONDisplayed when the Lone Worker function is ON.MOTION SENSOR ICONDisplayed when the Motion Sensor function is ON.NOISE CANCEL ICONDisplayed when the Noise Cancel function is ON.SURVEILLANCE ICONDisplayed when the Surveillance function is ON.☞ Continued on the next page