Icom IC-F8101 Service Manual

Also see for IC-F8100: Instruction manual Instruction manual Instruction manual Service manual Manual

Contents

5-10ADJUSTMENT TRANSCEIVER’SCONDITION OPERATION ADJUSTMENTITEM VALUEALCCURRENT1 • Channel: 25• Mode: CW• Receiving• Test equipment1) Connect the test equipment tothe antenna connector.2) Connect an ammeter betweenthe transceiver and the powersupply.3) C o n n e c t t h e c h e ck p o i n t“FOR” on the PA-A UNIT tothe ground.NOTE: Adjust this adjustmenti t e m s a s q u i c k l y a spossible.(Config Menu)* "RF Power" "HIGH"2 Simple 21/30(Factory Menu) "ICCV" "0"3 Simple 24/30(Factory Menu) "TX High Power" "255"4 • Transmitting Simple 21/30(Factory Menu) "ICCV" 27.5 A5Simple 24/30(Factory Menu) “TX High Power”"0"5-3 TRANSMIT ADJUSTMENTS (Continued)*; Enter the Confi g Menu as shown below.1) Push [ ] to return to the Main Menu.2) Select “Setmode” and push [ ] to enter, and then select “Config” using []/[].3) Select “RF Power,” and then set the TX power.4) Return to the Factory Menu to continue the adjustment.• ADJUSTMENT POINT ON THE PA-A UNITALC CURRENTCHECK POINT(FOR)