PROBLEM POSSIBLE CAUSE SOLUTION REF.No sound from speaker. • Squelch level s too hgh.• Volume level s too low.• Speaker has been exposed to water.• Internal speaker s turned OFF.p. 8p. 8p. 13p. 107• Set [SQL] to the threshold pont.• Set [VOL] to a sutable level.• Dran water from the speaker.• Turn the nternal speaker ON n Set mode.The transcever doesnot turn ON.• Bad connecton to the power supply. pgs. 109,110, 112• Check the connecton to the transcever.Transmttng s mpos-sble, or hgh power cannot be selected.• Some channels are programmed for lowpower or receve only n regulatons.• The output power s set to low.pgs. 7,8, 121p. 8• Change channels.• Push [H/L] to select hgh power.Scan does not start. • TAG channel s not programmed. • Set the desred channels as TAG channels. p. 16No beeps. • Beep tones are turned OFF.• The squelch s open.• Turn the beep tone ON n Set mode.• Set [SQL] to the threshold pont.p. 107p. 8Dstress call cannot betransmtted.• MMSI (DSC self ID) code s not programmed. • Program the MMSI (DSC self ID) code. p. 18118New2001TROUBLESHOOTING9