Setting Favorite channelsYou can quickly recall often-used channels by setting themas Favorite channels, which can be independently assignedto each channel group.Hold downq [U/I/C] (CH/WX) for 1 second to change thechannel group, if needed. Repeat to go to the next group.Select the desired channel to be set as a Favorite channel.wHold downe [*] for 1 second.• The displayed channel is set as a Favorite channel.• “ ” appears on the display.Selecting a Favorite channel:➥ Push [FAV] several times to select the desired Favoritechannel.• Non-Favorite channels are skipped and not displayed.• You can also select the favorite channels by pushing [Y] or [Z]while holding down [FAV].Clearing a Favorite channel:Select the desired Favorite channel you want to clear.qHold downw [*] for 1 second.• “ ” disappears.Clearing all Favorite channels:➥ While holding down [*] (FAV), turn ON the power.• All Favorite channels in the selected channel group are cleared.• When no channel is set as Favorite channel:Holding down [*] (FAV), turn ON the power sets all channels asFavorite channels.Starting a scanHold downq [U/I/C] (CH/WX) for 1 second to change thechannel group. Repeat to advance to the desired group.• When the Weather Alert function is in use, select a desiredweather channel by pushing [CH/WX] and [Y] or [Z].Pushw [SCAN] to start a scan.• “SCAN” blinks while scanning.• During a priority scan, “16” appears on the sub channel readout .• When a signal is received, the scan pauses until the signaldisappears, or resumes after pausing 5 seconds, depending onthe Scan Resume Timer setting.To stop the scan, pushe [SCAN] again.• “SCAN” disappears.• Pushing [PTT], [16/C], [CH/WX] or [FAV] also stops the scan.NOTE:In order to properly receive signals, the squelch must beadjusted to the proper level. (Page 11) 155SCAN OPERATION (All except the HOL version)12345678910111213141516[Example]: Starting a normal scan.PushBlinksBlinksScanning startsWhen a signal is receivedAppears