3BASIC OPERATION6rc- Receiving and transmittingCAUTION: Transmitting without an antenna may dam-age the transceiver.q Turn [VOL] right to turn power ON.w Set the audio and squelch levels.➥ Rotate [SQL] fully counterclockwise in advance.➥ Rotate [VOL] to adjust the audio output level.➥ Rotate [SQL] clockwise until the noise disappears.e Push [Y]/[Z] to select the desired channel. (p. 5)• When receiving a signal, “BUSY” appears and audio is emittedfrom the speaker.r Push [H/L] to select the output power if necessary.• “LOW” appears when low power is selected.• Choose high power for stronger signal propagation.• Some channels are for low power only.t Push and hold [PTT] to transmit, then speak into the mi-crophone.• “TX” appears.• Channel 70 cannot be used for transmission (for DSC use).Simplex channels, 3, 21, 23, 61, 64, 81, 82 and 83 CAN-NOT be lawfully used by the general public in U.S.A. wa-ters.y Release [PTT] to receive.IMPORTANT: To maximize the readability of your trans-mitted signal, pause a few sec. after pushing [PTT], holdthe microphone 1 to 2 inches (2.5 to 5 cm) from yourmouth and speak at a normal voice level.F..