ghan-ning.ups todis-oupl tag Starting a scanSet scan type (priority or normal scan) and scan resume timerin advance using set mode. (p. 20)q Set tag channels as described at left.w Make sure the squelch is closed to start a scan.e While pushing [H/L], push [CH/WX] one or more times toselect the desired channel group, if desired.r Push [Y] or [Z] for 1 sec. to start priority or normal scan.• “Pri scan 16” or “Normal scan” appears in the function display.• When a signal is detected, scan pauses until the signal disap-pears or resumes after pausing 5 sec. according to set mode set-ting. (Channel 16 is still monitored during priority scan.)•While in the scanning, use [Y] and [Z] key to check tag channels,change the scanning direction or resume the scan manually.• “16” flashes and a beep tone sounds when a signal is receivedon Channel 16 during priority scan.• Push [Y] and [Z] for 1 sec. to set the paused channel as a tagchannel.t To stop the scan, push [Y] or [Z].Scan starts. When a signal is received