136DSC OPERATION56n MMSI code programmingThe 9-digit MMSI (Maritime Mobile Service Identity: DSC selfID) code can be programmed at power ON.This code programming can be performed only twice. Afterthe code programming, it can be changed only by yourdealer or distributor.q Turn OFF the power.w While holding down [MMSI](MENU), turn ON the power toenter the MMSI code programming mode.e After the display appears, release [MMSI](MENU).r Push [MENU] to enter the DSC menu.t Push [Y] or [Z] to select “MMSI,” then push [ENT].• A cursor starts blinking.y Push [Y] or [Z] to select the specified MMSI code.• Push [CH/WX] or [16] to move the cursor forward or backward.u After programming the 9-digit MMSI code, push [ENT].• “CONFIRMATION” scrolls in the channel comment display.Scrollsi Push [ENT], then input the same MMSI code as step yfor the confirmation.o Push [ENT] to set the code.• Selects to normal operation.• Push [CLR] to cancel and exit the programming mode, if de-sired.• If a different code is input, “INCORRECT” appears. In that case,push [ENT] to repeat steps y to i again.D MMSI code checkThe 9-digit MMSI (DSC self ID) code can be checked.➥ While in the stand-by mode, hold down [MMSI](MENU) for1 second to display the 9-digit MMSI (DSC self ID) code.• The MMSI code is displayed and scrolls in the channel commentdisplay.• When no MMSI code is programmed, “NO MMSI” appears andwarning alarm sounds.Scrolls