Icom IC-M504A Instruction Manual

Also see for IC-M504A: Instruction manual Instruction manual

Contents

156DSC OPERATION■ MMSI code programmingThe 9 digit MMSI (Maritime Mobile Service Identity: DSC selfID) code can be programmed at power ON.This initial code setting can be performed only once.After being set, it can be changed by only your dealeror distributor.q First, turn OFF the power. Then, while holding down[MENU], push [POWER] to turn ON the power to enter theMMSI code programming mode.w After the display appears, release [MENU].e Enter “MMSI Check” in the DSC Set up menu.DSC Menu ➪ Set up ➪ MMSI Check(Push [MENU]) (Rotate [DIAL], then push [DIAL•ENTER].)r Rotate [DIAL] to input the specific 9 digit MMSI code.• Push [16•9] to move the cursor forward, or [CH/WX•DUAL•U/I/C] to move it backward.• Push [CLR] to cancel and return to the Set up menu.--DSC Menu--MMSI Check_________Exit / ENT˘OK>t After inputting the 9 digit code, push [DIAL•ENTER] toprogram.• Returns to the set up menu.y Push [CLR], or rotate [DIAL] to select “Exit” then push[DIAL•ENTER], to return to the DSC menu.• Push [DIAL•ENTER] again to return to the normal operatingmode.The programmed MMSI code can be checked in the DSC Setmode. (p. 45)12345678910111213141516