Icom IC-M505 Instruction Manual

Also see for IC-M505: Instruction manual Instruction manual Instruction manual

Contents

Icom IC-M505 Instruction Manual Manual pdf 10 page image

42 PANEL DESCRIPTION■ Function displayBUSY 25W INT CALLRX DUPSCRAM TAGNORMAL SCAN-34°34.506N123°23.236WLocal 1:10 CALLINGq w e r t y!4!3!1!0!2 iouq RX SPEAKER INDICATOR (p. 51)Appears during the RX Speaker mode.w POWER INDICATOR (p. 8)➥ “25W” appears when high power is selected.➥ “1W” appears when low power is selected.e TAG CHANNEL INDICATOR (p. 13)Appears when a TAG channel is selected.r DUPLEX INDICATOR (p. 7)Appears when a duplex channel is selected.t CHANNEL GROUP INDICATOR (p. 7)Indicates whether an International “INT,” U.S.A. “USA,”DSC “DSC” or ATIS “ATIS” channel is in use. (Dependson version)y CALL CHANNEL INDICATOR (pp. 6, 9)Appears when the call channel is selected.u LOW BATTERY INDICATORBlinks when the battery voltage drops to approx. 10 V DCor below.i CHANNEL NUMBER READOUTIndicates the selected operating channel number.o CHANNEL COMMENT INDICATORChannel comment appears if programmed. (p. 10)• “WAIT” blinks while transmitting or operating the hailer funci-tion, by using an optional command microphone. (p. 52)!0 TIME ZONE INDICATOR➥ Shows the current time data when a GPS receiver isconnected, or the time data is manually programmed.• “??” may blink every 2 sec. instead of current time data,when the GPS current time data is invalid. After 23.5 hourshave passed, “No Time” will appear.• “??” may blink every 2 sec. instead of current time data,after 4 hours have passed from the time that was manuallyprogrammed. The manually programmed time data is heldfor 23.5 hours only, and after that, “No Time” will appear.➥ “Local” appears when the offset time data is set.(p. 47)➥ “No Time” appears when no GPS receiver is con-nected and no time data is input manually.