Icom IC-M505 Instruction Manual

Also see for IC-M505: Instruction manual Instruction manual Instruction manual

Contents

Icom IC-M505 Instruction Manual Manual pdf 21 page image

156DSC OPERATION56■ MMSI code programmingThe 9-digit MMSI (Maritime Mobile Service Identity: DSCself ID) code can be programmed at power ON.This code programming can be performed only once.After the code programming, it can be changed onlyby your dealer or distributor.q Turn power OFF.w While pushing [MENU], turn power ON to enter MMSIcode programming condition.e After the display appears, release [MENU].r Push [MENU] again to enter the DSC menu.t R o t a t e [ C H A N N E L ] t o s e l e c t “ S e t u p ,” p u s h[CHANNEL•ENTER].--DSC Menu--Select ItemPosition InputReceived Calls˘Set upExity Rotate [CHANNEL] to select “MMSI Check,” push[CHANNEL•ENTER].--DSC Menu--Set upAdd:INDV IDAdd:Group IDDEL:INDV IDDEL:Group IDOffset Time˘MMSI Checku Rotate [CHANNEL] to set the specific 9-digit MMSI code.• Push [16•C] or [DIAL•DUAL/GRP] to move the cursor forwardor backward, respectively.• Push [CLR] to cancel and return to the set up menu.--DSC Menu--MMSI Check_________Exit / ENT˘OK>i After entering the 9-digit code, push [CHANNEL•ENTER]to set the code.• Returns to the set up menu.o Push [CLR] or rotate [CHANNEL] to select “Exit,” push[CHANNEL•ENTER].• Returns to the DSC menu.• Repeat again to return to the normal operation condition.Information for FRG versionThe DSC channel group MUST be selected before enter-ing the DSC menu. (p. 7) If other channel group is selected,DSC operation cannot be performed.• You should select the DSC channel group before turning powerOFF for entering the MMSI code programming condition.