Icom IC-M700PRO Instruction Manual

Also see for IC-M700PRO: Instruction manual Service manual Servise manual Instruction manual Instruction manual

Contents

Icom IC-M700PRO Instruction Manual Manual pdf 10 page image

63 SELECTING A CHANNELD Scan functionThe scan function allows you to automatically searchchannels within a group for signals. There are 2 scantypes (selectable in set mode) as follows:Scan operation➀ Rotate the [GROUP] selector to select the groupyou wish to scan.➁ Push [SQL] to close the squelch if necessary.• “SQL” appears.➂ Push [SCAN] to start scanning.• “SCAN” appears.➃ Push [SCAN] again to stop scanning.• “SCAN” disappears.Channel scanch 1ch 2 ch 3ch 4ch 5ch 50scan iscancelledwhentransmittingChannel resume scanch 1ch 2 ch 3ch 4ch 5ch 50scan pausesfor 10 sec. afterthe squelchopens,then resumes Selecting a frequencyThe transceiver has 0.5 to 30.0 MHz general coveragereceive capability with 100 Hz resolution. Use VFOmode to select frequencies around the prepro-grammed channels in memory mode.NOTE: Frequencies selected in VFO mode are fortemporary use and are not stored in memory.➀ While in memory mode, rotate the [GROUP] and[CHANNEL] selectors to select the channel nearestthe frequency you want.➁ Push [CH/FREQ] to select VFO mode.• “FREQ” appears.➂ Rotate the [CHANNEL] selector to select the de-sired frequency.• Frequency changes in 100 Hz steps.Rotate[CHANNEL]to select afrequency in0.1 kHz steps1.6 MHz selected1.6001 MHz selectedSIMPSQLSIMPSQL