Icom IC-M700PRO Instruction Manual

Also see for IC-M700PRO: Instruction manual Service manual Servise manual Instruction manual Instruction manual

Contents

Icom IC-M700PRO Instruction Manual Manual pdf 15 page image

115SET MODE Set mode operationSet mode operation is used for programming infre-quently changed values or conditions of functions.✍ NOTE: Some of the set mode items described inthis section are not available on some transceiverversions.➀ Push [POWER] to turn power off, if necessary.➁ While pushing [ENT] + [1], push [POWER] to turnpower on and enter set mode.➂ Rotate the [GROUP] selector to select the desireditem.➃ Rotate the [CHANNEL] selector to set the values orconditions for the selected item.➄ Turn power off and on again to exit set mode.[POWER]ConditionItem[ENT][1](1) Connected antenna tunerThe transceiver has several tuner control systems foruse with an optional Icom antenna tuner. Select thecondition depending on the connected antenna tuner.NOTE: Internal switch selection may be requiredwhen using a non-Icom tuner (p. 19).AT-130(default)AT-120AH-3(2) Automatic tuning conditionWhen the optional AT-130 automatic antenna tuner isconnected, tuning can be started automatically with-out the [TUNE] switch, for instant operation.If manual tuning is required, this automatic operationcan be deactivated.Tuning starts when pushing[PTT] on a new frequency.Tuning starts only when[TUNE] is pushed.(default)(3) Scan type selectionThis item sets scan to function as “channel scan” or“channel resume scan.”Both channel scan and channel resume scan searcharound a user selected channel or search in the bandwhen a channel is selected.Channel scanScan is canceled whentransmitting.Channel resume scanScan pauses when squelchopens, then resumes after10 sec.(default) Set mode contents