Icom IC-R8600 Service Manual

Also see for IC-R8600: Instruction manual How-to guide Reference guide

8--1SECTION 8 REPLACING FUSERWARNING!• Disconnect the DC power cable from the receiver beforereplacing the fuse.• NEVER use fuses that are not specified.If a fuse blows, or the receiver stops functioning, findand repair the cause of the problem. Then replace thedamaged fuse with a new, adequately rated fuse.The fuses are installed in the DC power cable and thecircuitry in the body, to protect the receiver.• DC power cable fuses .................................3 A/125 V• Circuitry fuse .........................................ATC 3 A/32 VD DC power cable fusesSee the following illustration to replace the blown DCpower cable fuse.D Circuitry fuse1. Remove the 10 screws, then remove the cover.2. Replace the circuitry fuse as shown below.CAUTION: When you remove a fuse, use longnose pliersto protect your fingers and the fuse holders.3. Replace the cover and the screws.ATC 3 A fuse3 A fuses