Icom ID-51A Basic Instructions

Also see for ID-51A: Manual Manual Basic instructions Brochure & specs User guide

Contents

Icom ID-51A Basic Instructions Manual pdf 73 page image

606D-STAR OPERATION6PROBLEM POSSIBLE CAUSE SOLUTION REF.After your call, the repeater doesnot return a status reply.• The repeater setting is wrong.• Your transmission did not reach the repeater.• Select the correct repeater.• Correct the repeater frequency, frequency off-set, or duplex settings.• Wait until you are closer to the repeater andtry again.• Try to access another repeater.p. 47——After your call, the repeater re-plies ‘UR?’ and its call sign.• The call was successfully sent, but no stationimmediately replied.• Wait for a while, and try again. —After your call, the repeater replies‘RX’ or ‘RPT?’ and the access re-peater’s call sign.• Your own call sign (MY) has not been set.• Your own call sign (MY) has not been regis-tered on a gateway repeater, or the registeredcontents do not match your transceiver’s set-ting.• Set your own call sign (MY).• Register your own call sign (MY) on a gatewayrepeater, or confirm the registration of the callsign.p. 13p. 15After your call, the repeater re-plies ‘RPT?’ and call sign of thedestination repeater.• The repeater cannot connect to the destina-tion repeater.• The repeater is busy.• Check the repeater setting.• Wait for a while, and try it again.p. 57—■ TroubleshootingTo communicate through the repeater, your signal must access to the repeater. When your signal accesses your local repeater,but it is not sent to the destination repeater, the repeater replies with an status message.D-STAR OPERATIONContinued on the next page☞