Icom MarineComander MXS-5000 Instruction Manual

Icom MarineComander MXS-5000 Instruction Manual Manual pdf 21 page image

2-52PLOTTER OPERATION123456789101112131415161718192021Vessel Offset function■ (MENU w Vessel Offset)This function locates your vessel icon at a specifiedoffset position from the center of the display to showyour COG large. The offset distance is calculated withthe specified offset value between the center and theedge of the display.Push [MENU], then rotate [DIAL] until the “VesselqOffset” menu is highlighted, then push [ENTER].Rotate [DIAL] to select the offset value, or turn thewvessel offset OFF.Push [ENTER] to set, then exit the “Vessel Offset”emenu.NOTE: While in the following status, the Vessel Off-set function is disabled;• The Plotter Display mode is “TM” (True Motion).• The COG data is disabled.• The SOG data is less than 2 knots.(When the SOG data rises more than 3 knots, theVessel Offset function can be used.)MENUWPTFOCUSLAYOUTMOBCLEARSUBBRILLRANGE[DIAL]/[ENTER][CLEAR][MENU]Originalposition When the offset valueis “2/3,” the icon is shift-ed to two-third from thecenter of the display.Plotter Display Mode selection■ (MENU w Plotter Display Mode)The plotter display has five modes, and it can be se-lected in the “Plotter Display Mode” menu.When the Plotter Display Mode is enabled, the plottermap moves to your vessel moving, and display rangeis changed centering around your vessel.The Plotter Display Mode is disabled when a cursor isdisplayed, or the plotter map is rotated by [DIAL].Push [MENU], then rotate [DIAL] until the “PlotterqDisplay Mode” menu is highlighted, then push [EN-TER].Rotate [DIAL] to select the desired mode betweenw“N-UP” (North-up). “C-UP” (Course-up), “AC-UP”(Automatic Course-up), “TM” (True Motion) and “AR”(Automatic Range). (p. 2-3)Push [ENTER] to set, then exit the “Plotter DisplayeMode” menu.