Icom ic-F3262DT Instruction Manual

Also see for IC-F3262DS: Instruction manual Operating guide

Icom ic-F3262DT Instruction Manual Manual pdf 18 page image

Turning power ON■Prior to using the transceiver for the first time, the batterypack must be fully charged for optimum life and operation.(p. 23)q Rotate [VOL] to turn ON the power.w If the transceiver is programmed for a start up password,input the digit codes as directed by your dealer.• The 10-keypad can be used for password input, depending onthe transceiver version.• The keys in the table below can be used for password input.• The transceiver detects numbers in the same block as identical.Therefore “01234” and “56789” are the same.KEYNUMBER 0549382716(Side1)P0 P1 P2 P3e If the “PASSWORD” indication does not clear after input-ting 6 digits, the input code number may be incorrect. TurnOFF the power and start over.Battery type selectionDWhen turning ON the transceiver, the battery type must beselected according to the attached battery type.Turn OFF the power.qWhile holding down [EMR] and [PTT], turn ON the powerwwith rotating [VOL] to toggle the attaching battery type.• After the display appears, release [EMR] and [PTT].• “ DRY BATT” is displayed for about 3 seconds, then the low powericon “Lo” appears when the battery case is selected. The trans-mit output power is automatically set to low1.• “LI-ION” is displayed for about 3 seconds when the Lithium-ionbattery pack is selected.• This operation may not be available, depending on the presetting.Ask your dealer for details.3 BASIC OPERATION13