Icom ic-U80 Instruction Manual

Also see for IC-U80: Instruction manual Quick guide

411010SET MODESD Frequency offsetSets the frequency offset to between 0 and 20 MHz, for re-peater operation.The frequency offset means the difference between thetransmit and receive frequencies.(default: differs depending on the version)D Reverse duplex functionTurns the Reverse Duplex function ON or OFF. (default: OFF)D Tuning stepSelects the tuning step from 5, 10, 12.5, 15, 20, 25, 30 and50 kHz. (default: differs, depending on the version)D Scan resume settingSets the scan resume setting to SCt. 5, SCt. 10, SCt. 15, orSCP. 2.When a signal is received during a scan, the scan pausesand then resumes according to the scan resume setting.• SCt. 5/10/15 : The scan pauses for 5, 10 or 15 seconds, and thenresumes. (default: SCt. 15)• SCP.2 : The scan pauses until the received signal disap-pears, and then resumes after 2 seconds.D Function key timerPush [FUNC](M) to enter the Function mode, and then pusha keypad key to activate its second function.• During the Function mode, “ ” is displayed on the LCD.Set the time between when Function mode is entered, andhow long it remains activated after you push the keypad keyto activate its second function.• F0.At : Exits the Function mode immediately after a key ispushed to activate its second function. (default)• F1/2/3.At : The Function mode remains activated for the selected pe-riod after a key is pushed to activate its second function.• F .m : The Function mode remains activated until [FUNC](M)is pushed again, even after a key is pushed to activateits second function.123456789111213141516171819