Classic Combi FF 280 - Installation 11Pack A Contentsz Combi modulez Boilerz Pack A1INSTALLATIONThe appliance is supplied as 2 separate modules (i.e. boiler module and Combi module) together with wall mounting plate(Pack A1) in one Pack A.Also supplied is a standard flue assembly for lengths up to 600mm (23 1/2"), rear or side flue outlet, in Pack B.Optional extras, if ordered (Extension Duct Kit D, Vertex Flue Kit G, Roof Flue Kit H and 90° Flue Elbow Kit) are available inseparate boxes.Unpack and check the contents.6 UNPACKINGPack B Contents:z Flue cutting support (cardboard) - 1 offz Terminal wall plate - 1 offz Terminal grille assembly - 1 offz Polyurethane foam seal 400 lg - 1 offz No. 8 x 8 lg. Pozi pan screw hd. screws - 3 offPack A1 Contents(contained within Pack A)z Installation & Servicing Instructionsz User's Instructionsz Hardware Pack (listed below)z Wall mounting templatez Wall mounting platez Stand-off brackets - 2 offz Side outlet terminal mounting plateHardware Pack Contentsz No.14 x 50mm wood screws - 8 off(for wall mounting plate)z No.10 x 50mm wood screws - 8 off(for side outlet plate and terminalwall plate)z Wall plugs - 16 offz M6 nuts - 8 off(for stand-off brackets)z M6 screws - 8 off(for stand-off brackets)z M6 washers - 8 off(for stand-off brackets)z Sealing plate - 1 off(for back panel)z M8 x 12mm screw - 1 off(for sealing plate)z M8 washer - 1 off(for sealing plate)z 22mm compression elbow - 1 off(for boiler / combi RETURN)z 22mm brass elbow - 1 off(for boiler / combi FLOW)z Plastic elbow extractor - 1 offz 7/8" sealing washers - 2 off(for CH flow and return)z 3/4" sealing washer - 1 offz 1/2" sealing washers - 3 off(for DHW inlet & outlet andCH expansion vessel)z 2 1/2" pozi-screw - 1 off(for Combi module cover)z Rubber gasket and screw - 1 off(bypass valve)z Terminal strip cover - 1 offz M5 washer - 1 offz M5 extended nut - 1 offz Flue extension tube - 1 offz M5 wing nut - 3 offz IEC mains plugz Boiler sealing plateINSTALLATIONFlue terminal Terminal wall plate