Classic Combi FF 280 - Installation 3155 HANDING OVERINSTALLATIONAfter completing the installation and commissioning ofthe system the installer should hand over to thehouseholder by the following actions:1. Hand the User's Instructions to the Householder andexplain his or her responsibilities under the Gas Safety(Installation and Use) Regulations 1994.2. Draw attention to the Lighting Instruction label affixed to thecontrols pod door.3. Explain and demonstrate the lighting and shutting downprocedures.4. The operation of the boiler and the use and adjustment ofALL system controls should be fully explained to theHouseholder, to ensure the greatest possible fuel economyconsistent with household requirements of both heatingand hot water consumption.Advise the User of the precautions necessary to preventdamage to the system and to the building, in the event ofthe system remaining inoperative during frosty conditions.5. Explain the function and the use of the boiler heating anddomestic hot water controls.6. Explain the function of the boiler overheat thermostat andemphasise that if cutout occurs, the boiler should beturned off and a CORGI registered installer consulted.7. Explain and demonstrate the function of time andtemperature controls, radiator valves etc., for theeconomic use of the system.8. If any Programmer Kit is fitted, then draw attention tothe Programmer Kit User's Instructions and hand themto the Householder.9. Loss of system water pressureExplain that the dial on the Combi module indicates thecentral heating system pressure and that if the normalCOLD pressure of the system (indicated by the redarrow in the dial) is seen to decrease over a period oftime then a water leak is indicated. In this event aCORGI registered installer should be consulted.DO NOT FIRE THE BOILER IF THE PRESSURE HASREDUCED TO ZERO FROM THE ORIGINALSETTING10. Stress the importance of regular servicing by a CORGIregistered installer and that a comprehensive serviceshould be carried out AT LEAST ONCE A YEAR.INSTALLATION