Ideal Boilers Classic FF 330 Installation And Servicing

Ideal Boilers Classic FF 330 Installation And Servicing Manual pdf 20 page image

20Classic FF - Installation & ServicingINSTALLATIONREAR & SIDE FLUE OUTLET33 FLUE EXTENSION DUCTS -For flue lengths greater than 600mm (Not for FF 3 100 model)32 TERMINAL WALL PLATE31 CONNECTING THE FLUE TO THE BOILER1. Pull the flue through the side outlet plate and locatethe 3 studs in the hole in the side of the boiler.2. Secure the flue to the boiler using the three M5 nutsprovided.3. Insert the flue extension tube into the flue.4. Fit the 90° flue elbow, supplied with the boiler, ontothe fan in the direction required, after first removingthe underside screw, which is not required. Securein position with the screw attached to the fan.5. Pull the flue extension tube and engage onto thefan elbow and secure with the screw attached to theelbow.Note.The sealing ring studs will locate in the backpanel one way only. This will ensure that the terminalgrille is correctly aligned.This plate allows neat concealment and fullcompression of the rubber seal. Its use is notessential if the flue hole and flue ducts have beenaccurately cut and the outside wall face is flat.1. Position the terminal wall plate over the terminal.2. Drill 4 fixing holes with a 7mm (9/32 ") masonry drill.3. Insert the 4 plastic plugs provided.4. Secure the plate with 4 of the No.10 x 2" screwsprovided.Note.If the terminal is less than 2m (6' 6") aboveground level, an approved terminal guard should befitted. Refer to the contents list on Page 3.PACK D Flue extension duct kit contents.