Ideal Boilers FF 330 Installation And Servicing

Also see for Classic FF 330: User guide

Ideal Boilers FF 330 Installation And Servicing Manual pdf 14 page image

14INSTALLATIONClassic Slimline FF - Installation & ServicingREAR FLUE OUTLETNote.If theterminal is to besited within 25-40mm of a corneror vertical pipe(refer to Table 3)then the holeMUST beaccurately cut andthe rubberweather sealtrimmed aroundthe grooveprovided.The terminal wallplate need not befitted.Note.Check all of the hole positions BEFORE drilling11 FLUE ASSEMBLY - Exploded ViewLEGEND1. Terminal.2. Weather seal.3. Flue assembly.4. Boiler sealing ring.5. Flue extension tube.1. An optional flueduct extension kitis required forwall thicknessesgreater than600mm (23 1/2 ")Refer to Frame 10.2. When cutting theducts, always usethe cardboardsupport ringsprovided.1. Separate the templates.2. Tape the templates into the selected position.3. Ensure squareness by hanging a plumb line asshown.4. Mark onto the wall (if required) the following:a. The wall mounting plate screw positions (chooseone from each group). Note.Mark the centre of theflue hole as well as the circumference.b. The position of the flue duct hole.5. Remove the templates from the wall.IMPORTANT. Ensure that, during the cutting operation,masonry falling outside of the building does not causedamage or personal injury.1. Cut the flue hole, preferably with a 125mm (5") core boringtool, ensuring that the hole is square to the wall. If the holehas been quite accurately cut with a drill then making goodthe wall faces is not essential as seals are provided atboth ends of the flue. However, both wall facesimmediately around the cut hole should be flat; make goodif necessary. For less accurate holes make good toapproximately 125mm (5") diameter at the 2 wall faces.2. Drill 2 holes for the wall mounting plate with an 8mm (5/16 ") masonry drill.3. Drill 1 further hole above the flue hole for boiler fixing withthe same 8mm (5/16 ") drill.4. Insert the plastic plugs provided.13 PREPARING THE WALL12 WALL MOUNTING TEMPLATE