Ideal Boilers Minimizer FF 30 Installation & Servicing

Minimiser - Installation12The boiler is supplied fully assembled in one Pack A, togetherwith a standard flue assembly for lengths up to 406mm, rear orside flue outlet, in Pack B.Optional extras, if ordered. (Programmer Kit, Roof Flue Kit,Extension Duct Kit D and Wall Mounting Stand-off Kit) areavailable in separate boxes.Unpack and check the contents.INSTALLATION11 UNPACKING12 PACKAGING AND PANEL REMOVALINSTALLATIONPack B ContentsNo. 8 x 8mm self tapping screws - 2 off.Flue support cutting aid - 1 off.Tube of sealant -1 off.No.10 x 2" screws - 4 off.Rawlplugs - 4 off.M5 x 10 pozi-pan head screw - 4 off.M5 Form C washers - 4 offz 50mm x No.10 wood screws -3 offz Wall plugs (TP2B ) - 3 offz Water treatment warning labelz Flue connector tubez Condensate drain adaptorz 22mm x 28mm flow andreturn pipe connectors (FF30to FF60 boilers ONLY)Hardware PackPack A ContentsAlso contained in Pack A:z Hardware Pack (listed below).z These Installation & Servicing Instructions.z The User's Instructions.1. Unpack the boiler.Note. The hardware pack and wall mounting plate arewithin the cardboard infill pieces.2. Swing open the controls pod door.3. Remove the single screw retaining the casing frontpanel.4. Lift the front panel upward and forward and place toone side to avoid damage.5. Close the controls pod door.6. Remove the boiler from its packaging base.