Part 1 – Introduction9OverviewFront Panel121 USB Ports 2 LEDs• Remote control sensor is located on the bottom center of the front panel. Ensure that the sensor remains unobstructed atall times. If obstructed, the sensor might not be able to receive remote control signals.• Placing a Wi-Fi, Bluetooth, or any other wireless communication device near the NVR may interfere with remote controlsignal transmission.• Access various windows and menus using a USB mouse as you would on a personal computer.• For easier system configuration, a USB mouse is recommended.1 USB Ports• Storage Device ConnectionConnect an external USB hard drive or a USB flash memory device to one of the USB ports for use with the ClipCopy feature. The external storage device should be placed as close to the NVR as possible. It is recommended thatyou use a connection cable that is no longer than 180cm in length. Use the connection cable included with yourexternal storage device to connect the device to one of NVR's USB ports. For more information Clip Copy, refer tothe Clip Copy in the operation manual.• Peripheral Device ConnectionUse the USB ports to connect peripherals such as a USB mouse to the NVR. You can also use a USB-to-serialconverter and connect multiple text-in devices to the NVR at the same time.For USB flash memory devices, the NVR supports the FAT32 file format only.