Jäger Z100-M628.03 S11 Manual

Tool changeItem no. 10206005, Revision 0230 ( 40 )10.2 Manual hollow shank taper1 Clamping segment2 Access hole3 Locking ring4 Threaded spindle5 Marking "X"6 Snap ring7 Ejector with withdrawal thread8 Basic body9 Driver10 Cam11 Shaft of HF spindle12 Mounting spindleExample of design: Joining positionExample of design: ClampingpositionÜ Turn the locking ring until the hexagon wrench can be guided axiallythrough the access hole to the hexagon socket of the mounting screw.Ä Width across flats: 3Ü Turn the threaded spindle counterclockwise until you feel it reach the stop.Ü Remove the hexagon wrench.Ü Before inserting the tool mount into the HF spindle, clean the following:Ä Plane surfaces of tool mountÄ Taper of tool mount.Ä Plane surfaces of shaft.Ä Inner taper of shaft.Ü Use the cleaning taper from the service set.Ü Insert the tool taper into the HF spindle.Ä See figure: Joining positionÜ Insert the hexagon wrench into the threaded spindle through the accesshole.Ü Tighten the threaded spindle clockwise with the tightening torque MAmax.Ä MA max: 6 NmÄ See figure: Clamping position