CM-200GE/CM-200GE-RA/CB-200GE/CB-200GE-RA- 37 -10. Operation ModesThe CM-200GE and CB-200GE series comply with GenICam SFNC (Standard Features NamingConvention) version 1.3 and the acquisition of the image, the trigger functions, the exposuresettings and so on are different from those used in early versions of these cameras.10.1. The functions related to GenICam SFNC 1.3The following functions are the most affected by SFNC 1.3.Features – Acquisition and Trigger ControlAcquisition modeThe image can be captured in two ways, continuous or single fame. ContinuousBy executing AcquisitionStart command, the image can be output until AcqusitionStop Trigger isinput. Single FrameBy executing AcquisitionStart command, one frame of the image can be output and then theacquisition is stopped.Trigger SelectorThis can be selected from FrameStart or TransferStart. FrameStartThe trigger pulse can take one frame capture. TransferStartThe trigger pulse can read out the image stored in the frame memory. This is used for thedelayed ReadoutTriggerModeThis selects either trigger mode (ON) or continuous mode (OFF).TriggerSoftwareThis is one of the trigger sources which enables trigger commands to be created using software.In order to use TriggerSoftware, TriggerSource should be set at Software.TriggerSourceThe trigger source can be selected from the following signals.
