JBL Control Control Now Owner's Manual

Contents

JBL Control Control Now Owner's Manual Manual pdf 10 page image

10HALF-ROUND WALL-MOUNTING(HORIZONTAL OR VERTICAL)NOTE: Decide whether you will connect the speakers as a single channelor two separate channels, and follow the appropriate instructions onthe following pages.CONNECT AS A SINGLE CHANNELCAUTIONThe customer is responsible for proper selection and use of mounting hardware(available through hardware stores), to properly and safely wall-mount thespeakers. The JBL Control NOW speaker was designed to be easily installed.However, if you are unable to clearly and fully understand and follow theinstructions in this manual, or if you are unsure of your ability to properly installthese loudspeakers, please contact your dealer or a qualified installer. Pleasedo not use any power tools during installation. Power tools can exert excessiveand unnecessary torque which, in turn, can damage fasteners or other partsand accessories, reducing their strength and causing possible failure of thefastener or part. A failed or damaged fastener or part may not be able toperform as designed, and may lead to an unsafe installation.1. Secure two corner/wall-mountingbrackets together by using two#10-32 x 1/2" (M5 13 mm) screws pro-vided, as shown. Attach the mountingbracket to the wall.When deciding upon a location for the JBL Control NOW speaker, take careNOT to install the mounting bracket closer than 3" (7,6 cm) (horizontal) and 8-1/2"(21,5 cm) (vertical) to the ceiling. Any closer than the minimum measurementswill not allow the room needed to position and slide the JBL Control NOWspeaker into the mounting bracket.8-1/2" (21,5 cm) Minimumdistance from ceiling(vertical mount)3" (7,6 cm) Minimumdistance from ceiling(horizontal mount)2. Attach the mounting bracket to the wall. Be sure to use appropriate anchors.Appropriateanchors3. Remove the terminal assemblies from the rear of both speakers. The terminalassembly is removed by giving it a slight counterclockwise rotation. Use thetransparent plastic strap to pull the assembly out, as shown.4. Connect the small end of the multiunit wiring adapter to one of the speakerrears, as shown.#10-32 x 1/2"(M5 13 mm)Screws (2)