JBL DVD600 Service Manual

Also see for DVD600: Owner's manual

Contents

Service BulletinService bulletin # JBL2003-10 December 2003 Warranty labor rate: MINOR repairTo: All harman/kardon Service CentersModel: DVD600Subject: Stays in Standby ModeIn the event you receive a DVD600 with one or more of these symptoms:• Unit stays in Standby mode (amber indicator light)• Unit will play for a time period, then goes into Standby mode (amber indicator light)Check and replace capacitors C10 and C11 in the power supply. Defective parts may not have any visualclues; they must be tested.Procedure:1) Remove the top cover.2) Disconnect the three ribbon connectors that connect the 5 disc main assembly to the decoder PCB (2)and power supply (1).3) Remove the 4 screws that hold the 5 disc main assembly down to the bottom panel.4) Pull the chassis slightly up in the rear, and pull the entire assembly out the back.5) To access the power supply, remove the six plated screws; unplug the two large Molex 2-pin connectors.6) Remove and replace: C10,C11: h/k part# P10248-ND ELECT 470uf 16v 105c radial capacitor7) Reinstall in reverse order. Take care not to pinch or crush any cables; assure ground terminal isreconnected on the front left chassis screw.21