JBL MR-32 Operation Manual

Contents

145x210mm2Wiring IdentificationInstallation NotesApplicable to both 2 and 4-speaker connection:A. ConnectionsB. Din cable connection for remote controlC. Din cable connection for SIRIUS controlD. CD change socketE. Antenna socketF. AUX-INThis radio contains four separate power amplifiers. To prevent possible damage tothese amplifiers, please ensure the following:i) The boat chassis is not used as a loudspeaker ground(-).ii) Front and rear loudspeaker connecting wires are not joined together.iii) Any wires not used when completing a two speaker installation are fully insulated.iv) The memory wire (yellow) is connected to a permanent + 12V supply.v) The power wire (red) is connected via the ignition switch of the boat.(AUTO ANT)( BACK-UP B+ )FUSE1A( GROUND )FUSE( IGNITION B+ )BlueYellowBlackRedGrayGray/BlackVioletViolet/Black( Front Right )( Rear Right )GreenGreen/BlackWhiteWhite/Black( Front Left )( Rear Left )10ARedWhiteBlackWhiteRedGrayRear Line outFront Line outCONNECTORABCF( Remote control )( SIRIUS control )( AUX-IN )D(CD changer socket)(ANT. socket)E111. Reset functionA microprocessor reset button has been provided to facilitate manual resetting of theinternal microprocessor in the unlikely event that the player fails to operate correctly.Should it be necessary to reset the microprocessor, simply open the face, removerubber plug and press reset button.Note: It will be necessary to re-enter the radio preset memories as these will havebeen erased when the microprocessor is reset. After resetting the player, ensurethat all functions are operating correctly.2. General PrecautionsIf the unit has become extremely hot, we strongly recommend that you allow it to cooldown before using. Take care of your CDs to preserve the quality of the recording.Do not allow them to be exposed to direct sunlight. Store them in a place protectedfrom dirt and dust and avoid handling them with oily, greasy or wet hands.Be sure the CD is put into the CD slot label side up.Precautions and MaintenanceCONNECTOR PIN: Always keep connector pin clean.If the PIN connector looks dirty, use cotton tips to clean it, so as to avoid anyunexpected malfunction caused by dirt.3. CautionCD slotCD EJECT buttonConnector pinReset button