JBL MR-32 Operation Manual
       | |
145x210mm4Important notesPrior to the final installation, carry out a sound check. If high distortion or intermittentsound is experienced, it is possible that the wiring from the CD receiver to the boat'selectrical system is poor or that the battery needs recharging.If the battery and its charging circuit are OK, then rewire the yellow fused wire of theCD player directly to the positive terminal (+) of the boat battery.Marine accessory shops stock the connector blocks and the 10 Amp cable that maybe necessary for extending the fuse wire connection.GroundingMake sure that the black wire on the wiring harness is connected to a good groundpoint on the boat. If the chassis of the boat is used as a grounding point, make surethat the surface is scraped clean of paint before attaching the wire to it.It is preferable to connect the black ground wire directly to negative terminal (-) ofthe boat battery.Warning: polarity...This model is only suitable for use in boats which have a negative ground system,e.g.: the negative terminal of the boat battery is connected to the chassis.Connecting the Speakers and Power CablesBefore you wire your system, disconnect your boat battery's positive (+) cable.This helps prevent damage in case of a short. When you complete the wiring,reconnect the battery cable and test your marine stereo. When connecting yourmarine stereo's black ground wire, be sure to connect the wire to a metal part ofyour boat or preferably to the negative (-) terminal of the boat battery.POSITIVECHASSISNEGATIVECHASSIS91. Manual/Seek tuning buttons (4): Press this button quickly to activate the Seekmode. The Seek mode will automatically seek up or down the wave band and stop atthe next station of sufficient signal strength. Press and hold tuning buttons for 2seconds to enter manual tuning mode. The unit will revert back to Seek mode after10 seconds without use.2. Manual Station store: Select the desired band and tune to a radio station to bememorized. Choose the preset button memory location1-6 into which the station isto be stored and press and hold that preset button for 2 seconds.The station will now be entered into the preset memory. 6 stations can be memorizedon each of the FM1, FM2, FM3, AM1, AM2.3. A/PS - Auto store function (16)Press and hold button (16) for approximately 2 seconds until you hear a beep toconfirm that the memory function is engaged. The unit will "SEARCH" for six strongstations and automatically store them in buttons 1 - 6.You can override the preset station for any button by manually setting a new frequency.4. Scan (14)In Radio mode, press the SCAN button (14) to scan strong stations for previewing.At the desired station, press the SCAN (14) button again to stop scanning.5. Program Memory ScanMomentarily press A.PS (16) button to scan for stored stations.Momentarily press it again to stop scanning.Station Tuning1837546168179 1012 13 14 151219111 5 6SEL MODE SH.SR 7.SCN 8.DISP 9.A/PS 0.LD BD.FNFLIP DOWN COMPACT DISC PLAYER HI-POWER 4x52WattsMR-32MARINE |
Related manuals for JBL MR-32
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine