JBL Project Everest DD65000 Product Commentaries And User Manual

Contents

33The DD65000 and DD67000 have two control panels under the cover at the centerbottom of the front baffle. Shorting bars and switches on the control panels allow you toswitch orientation of the system, engage bi-amplification if desired and adjust woofer andhigh-frequency levels. After removing the grille (see Removing the Grilles, in Chapter 3),remove the control panel cover to expose the adjustments.To change setups using shorting bars, use the supplied hexagonal driver to remove thescrews securing the bar. Move the bar according to the setup you require and then re-install the screws.attention: To avoid poor electrical contact caused by loose shorting bar mountingscrews, make sure that the screws are firmly installed. However, if you overtighten, thereis a risk of damaging the terminals themselves. Please use the supplied hexagonal driverand tighten screws with reasonable torque, by hand only. DO NOT USE POWEREDSCREWDRIVERS OF ANY TYPE.Project everestaDjustments7