JBL Soundzone SMS1 Owner's Manual

Also see for Soundzone SMS1: Technical manual

Contents

19POWER CAPABILITYSMS1-Sub:SMS1-Sat:SPL Capability (1W, 1m):SMS1-Sub:SMS1-Sat:INPUTSMusic (use only one of the following):Microphone:Internal Crossover:Remote Volume Control Jack:SETTINGSProtected ControlsSubwoofer Polarity:Crossover:Bass Trim:AutoWarmth:Page Threshold:Speaker EQ:User Accessible Controls:Music:Mic:MODELS:SMS1SMS1-WHSMS1/230SMS1-WH/230SMS1-SUBSMS1-SUB-WHSMS1-SUB/230SMS1-SUB-WH/230OPTIONAL ACCESSORIES:Z-M1 Paging Microphone:ZR-V Remote Wallplate:ZR-IWB In-Wall Electrical Box:ZR0OSB On-Surface Electrical Box:80 Watts Continuous pink noise160 Watts Continuous program240 Watts Continuous peak10 Watts Continuous pink noise (x 4 speakers)20 Watts Continuous program (x 4 speakers)40 Watts Continuous peak (x 4 speakers0104 dB average, 108 dB peak.92 dB average, 98 dB peak (x 4 speakers)Pro Line Level Input: +4 dBu nominal, balanced, Euroblock connectorConsumer Line Level Input: =10 dBV nominal, unbalanced, RCA connector.(See Note 1, below if using the Consumer Line Input)Speaker Level Input: For 70V or 100V speaker lines, Euroblock connectorBalanced, Euroblock connector, switchable phantom power for condensermicrophones. Band limited 200 Hz – 8 kHz24 dB/oct low-pass to the subwoofer amp/driver.24 dB/oct high-pass to the satellite amp/speakers.RJ45 connector, for standard UTP Category 5 cable. Uses ZR-V remote wallplate.Sets the polarity of the input signals so the bass to the subwoofer adds properly.Positions:In Polarity (Normal)Out of Polarity.Sets the crossover frequency of the subwoofer.Positions:160 Hz (Normal) – for normal operation of SMS1 system.80 Hz – when using SMS1 Sub to augment the bass of another speakersystem, to avoid muddy overlap with fullrange speakers.Adjusts subwoofer level relative to that of the satellite speakers.Control: Variable rotary controlAutoWarmth automatically adjusts tonal balance to sound full at low volumes.Indicator: LED, lights when AutoWarmth is activated.Control: Variable rotary controlAdjusts threshold where microphone signal triggers music ducking.Built-in EQ is specifically set up for SMS1-Sats.Positions: On (Normal), OffAdjusts volume of music sourceAdjusts volume of the paging microphoneCharcoal Gray, 120 VACWhite, 120 VACCharcoal Gray, 230 VACWhite, 230 VACPowered Subwoofer, Charcoal Gray, 120 VACPowered Subwoofer, White, 120 VACPowered Subwoofer, Charcoal Gray, 230 VACPowered Subwoofer, White, 230 VACDynamic (leave phantom power off), 600 ohms, balancedWallplate for remote adjustment of music volumeU.S. Size electrical box for use with ZR-V. For countries where U.S. size boxesare not be available. Contains side dogear clamps to clamp onto wall surface.U.S. Size electrical box for use with ZR-V. For countries where U.S. size boxesmay not be available. Mounts on the surface of the wall.SpecificationsNote 1: If positioning of the Subwoofer requires the use of a long unbalanced (RCA) input cable for themusic, then buffering and/or balancing of the signal via an external device at the source might benecessary in order to make sure the audio fidelity is not compromised before getting to the SMS1 system.

/ 24

Related manuals for JBL Soundzone SMS1