41VTX B 18 | Rigging Manual9.5 - USING THE VTX A8 SB FOR PULL-BACKThe Suspension Bar can be used for pull-back at the bottom of a B18 array to support array configurations that require a significantamount of down-tilt. In this case, the VTX A8 AF or an additional Suspension Bar can be used at the top of the array as the primaryattachment point. In the latter case, the Suspension Bar must be connected to the two center rigging points of the B18. This allows foran easier and safer assembly since the array remains straight during setup. When the main array frame is used, the Extension Bar hole8-B can be used which also allows for a straight array during setup.STEPS:• First assemble the B18 array based on the instructions from chapter 8 and chapter 9• Extend the Suspension Bar tabs as shown in chapter 9.2• Attach the Suspension bar to the bottom B18123
