JETWAY 845CAR1A User Manual

Contents

JETWAY 845CAR1A User Manual Manual pdf 40 page image

373-11 Miscellaneous ControlThis section is for setting CPU Frequency/Voltage Control.CMOS Setup Utility – Copyright(C) 1984-2001 Award SoftwareMiscellaneous ControlItem HelpCPU Clock Ratio X 8Auto Detect PCI Clk EnabledSpread Spectrum Disabled** Current Host Clock is 100/33MHz **HOST/PCI Clock at Next Boot is 100/33MHz** Current DRAM Clock is 133MHz **DRAM Clock at Next Boot is 133MHzPCI Clock Ratio Host/3Vcc1.5 Select 1.5VFlash Part Write Protect EnabledMenu Level >Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General HelpF5:Previous Values F6:Optimized Defaults F7:Standard DefaultsAuto Detect PCI ClkThis item allows you to enable/disable auto detect PCI Clock.The settings are: Enabled, Disabled.Spread SpectrumThis item allows you to set the CPU Host/PCI clock and Spread Spectrum.The settings are: Enabled, Disabled.Host/PCI Clock at Next BootThis item allows you to select CPU frequency step by step increasing.The choice are: 100MHz∼200MHzDRAM Clock at Next Boot isThis item allows you select the DRAM Clock same as Host clock, or can add 33MHz whenHost Clock under 109MHz.PCI Clock RatioThis item allows you to set PCI Clock Ratio. The choice are: Host/3, Host/4, Host/5,Host/6.Vcc1.5 SelectThis item allows you to select 1.5V of the AGP VGA card. The choice are: Default, 1.5V,1.6V.Flash Part Write ProtectThis item allow you protect your BIOS chip from Virus destroy data. When Flash BIOS youhave Disabled this item.