333-7-3 Onboard Super IO FunctionCMOS Setup Utility – Copyright(C) 1984-2003 Award SoftwareOnboard Super IO FunctionItem HelpOnboard FDD Controller EnabledOnboard Serial Port 1 3F8/IRQ4Onboard Serial Port 2 2F8/IRQ3UART2 Mode NormalRxD, TxD Active Hi, LoIR Duplex Mode HalfUse IR Pins IRRX/IRTXOnboard Parallel Port 378/IRQ7Parallel Mode SPPEPP Mode Select EPP1.7ECP Mode Use DMA 3Menu Level >>↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General HelpF5:Previous Values F6:Optimized Defaults F7:Standard DefaultsOnboard FDD ControllerSelect Enabled if your system has a floppy disk controller (FDD) installed on the system boardand you wish to use it. If you install add-on FDC or the system has no floppy drive, selectDisabled in this field. The settings are: Enabled and Disabled.Onboard Serial Port 1/Port 2Select an address and corresponding interrupt for the first and the second serial ports. Thesettings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.UART2 ModeThis item allows you to determine which InfraRed(IR) function of the onboard I/O chip, thisfunctions uses.Onboard Parallel PortThere is a built-in parallel port on the on-board Super I/O chipset that Provides Standard, ECP,and EPP features. It has the following option:Disabled(3BCH/IRQ7)/ Line Printer port 0(278H/IRQ5)/ Line Printer port 2(378H/IRQ7) Line Printer port 1Parallel Port ModeSPP : Standard Parallel PortEPP : Enhanced Parallel PortECP : Extended Capability Port