J-20015.2 Pump Does Not Operate But Light DoesPress the JETS 1 button:1. If no water movement is detected, make sure power is going tothe spa and check the water level. If it does not solve the problem,contact your authorized Jacuzzi dealer or qualified servicetechnician.2. The main jets pump 1 operates but no water flows to jets. Check thefollowing:• Jets may all be closed in spa. Verify all jets are in the open “on”position (Sec. 10.4, page 26).• Pump may not be properly primed. This can happen after the spa isdrained and refilled. Press the JETS 1 button on the control panelseveral times, never leaving the motor running for more than 5 to 10seconds at a time. Turn power off and let the air out of spa plumbingsystem by removing the filter cartridge (Sec. 12.1, page 32). Makecertain you reinstall the filter cartridge before turning on spa powerand restarting the jets pump 1.15.3 Poor Jet Action1. Make sure jets are in the full open “on” position (page 26).2. Press the JETS 1 button to make certain pump #1 is on.3. Open all air controls to their full on position (counterclockwise).4. Check for dirty filter. Clean, if necessary (Section 12.1, page 32).15.4 Water is Too HotReduce thermostat setting.15.5 No Heat1. Check thermostat setting.2. Keep the spa cover in place while heating.3. Check the settings to see if your spa is in economy filtration/heatingmode (page 28).Should checking the above steps fail to correct the problem, please callyour dealer so that they may arrange service. We build the best spas inthe industry. Nonetheless, we are always striving to improve the qualityand features of our products.Your input as a Jacuzzi spa owner is a cherished part of this process. Ifyou have any comments or suggestions, or if you wish to be informed onany new products for your spa, please write to us.CONGRATULATIONS on your good taste and welcome to the happiestand most relaxed family in the world!47