Jacuzzi J-315 Installation Manual And Use & Maintenance

Also see for J - 355: Manual Instructions for preinstallation Instructions for preinstallation Owner's manual Owner's manual

Contents

Jacuzzi J-315 Installation Manual And Use & Maintenance Manual pdf 27 page image

L1: Full lock out (disables all spa functions to permit filter cleaning)L2: Partial lock out(disables the buttons for jets and light to prevent unautho-rized use of the spa). In this mode, the skimming/heatingmode continues to operate as programmed. The temperaturedisplay flashes when this function is enabled. Example: the“F3” skimming/heater cycle was enabled prior to choos-ing lock mode. The spa continues to perform the “F3” cy-cle until lock mode is cancelled, allowing another cycle tobe selected.NOTE: To exit a Lock Mode you will need to re-enter the fil-tration/heating modes and select a cycle from F1-F6. To set the time of the first skimming/heating cycle connect thespa to the power supply two minutes before the desired time.EXAMPLE: If you desire your first skimming/heater cycle to beginat 10:00 AM turn off power to the spa and turn it back on again at9:58 AM. Selecting the Circulation Pump Filtration CyclePress and hold the Jets pump 1 ( ) and Cooler ( ) buttonat the same time for 3 seconds to access the circulation pumpprogramming. Continually press the Warmer ( ) button toscroll up through the cycles below. Then select a cycle and pressthe Jets pump 1 ( ) button to activate that cycle. Upon press-ing the jets pump 1 button the system will save your selection,exit the program menu and return to the main menu.Note: After 10 seconds the programming screen will revertback to the temperature if no buttons are pressed. You cannothave more than one circulation pump cycle activated at a time.0 hours of circulation per day4 hours of circulation per day8 hours of circulation per day (recommendedfactory default setting for J335-J375 models)12 hours of circulation per day16 hours of circulation per day20 hours of circulation per day24 hours of circulation per day(recommended factory default setting for J315models)Programming the Clearray (Ultraviolet)Programming the CLEARRAY System (U) or Corona Dis-charge Ozone (O3) (where included)Press and hold the Jets pump 1 ( ) and Cooler ( ) but-ton at the same time for 3 seconds. Scroll pass the circulationpump programming menus by pressing the Warmer button.After the last cycle, “C6”, the LED screen will display “U” or “O3”.If the LED screen is displaying “U” then pressing the Jets pump1 will change the sanitizing system from “U” to “O3” and exit theprogramming menu. If the LED screen is displaying “O3” thenpressing the Jets pump 1 will change the sanitizing system from“O3” to “U” and exit the programming menu. You will see one ofthe two configurations below:A. C0, C1, C2, C3, C4, C5, C6, U, 365 (duration countdowntimer)B. C0, C1, C2, C3, C4, C5, C6, O3, =Note: For the O3 option the “=” disables the duration count-down timer. If you do not wish to change the option do notpress any buttons and after 10 seconds the display will returnto the main menu.If the CLEARRAY System has been selected, when the timeallotted has expired (365 days) the display screen will flashbetween the water temperature and “blb”. At this time the UVlamp bulb must be replaced, the quartz tube must be cleanedand the duration countdown timer needs to be reset. Resetting the duration countdown timer (CLEARRAYSystem only)Once the duration countdown timer for the CLEARRAY Systemhas reached zero, you will need to reset it, replace the UV lampbulb and clean the quartz tube.To reset the duration countdown timer:Press and hold the Jets pump 1 ( ) and Cooler ( ) but-ton at the same time for 3 seconds.Press the Warmer ( ) button until the display shows “0”.If the timer has reached “0”, pressing the Jets pump 1 ( )button will reset the counter. If the timer is not at “0” pressingthe Jets pump 1 button will not reset it.Note: If the spa power is interrupted, the duration countdowntimer is not affected. The number of days remaining is stored in27Press Press Press Press PressPressPressPress PressWill reset the timerto 365 days and exitthe menuPress Press Press Press PressPressPressWill take youback to “C0”Will select“O3” optionand exit menuPressPress Press Press Press PressPressPressPressWill reset the timerto 365 days and exitthe menuPress Press Press Press PressPressPressPressWill select “03”option and exitmenuWill take youback to “C0”Press