Jacuzzi Select Series Owner's Manual
Contents |
IMPORTANT SAFETY INFORMATIONREAD AND FOLLOW ALL INSTRUCTIONSRead manufacturer’s safety information provided with all optional equipment.Warning — Risk of injury: Children, the elderly, and theinfirm should not use the spa unless they are supervised at alltimes. Infants should not be permitted in the spa at watertemperatures over 100° F (38°C).Spa water temperatures in excess of 104° F are notrecommended. High water temperatures in excess of 104° F(40° C) and prolonged periods of use can raise internal humanbody temperature excessively and impair the body’s ability toregulate its internal temperature.Pregnant women and people with heart circulatory condi-tions, or diabetes, should consult their physicians before usingthe spa at water temperatures over 100° F (38° C).Limit your initial use of the spa to 10 - 15 minutes. Highbody temperatures affect people differently; consult your phy-sician about your safety and comfort before using the spa.Extra care should be taken when using the spa andconsuming alcoholic beverages. Alcohol, drugs, or certainmedications, such as tranquilizers, affect a person’s ability towithstand high temperatures and may produce dangerouseffects, including drowning. Persons using medication shouldconsult with a physician before using a spa.Danger — Risk of injury: Do not remove the suction grille! Itis a safety device and must always be in place on the suctionfitting to minimize the potential hazard of hair entanglement orbody entrapment.Keep body, hair, and clothing a minimum of 12 inchesaway from suction fitting and skimmers at all times when thespa is operating. Hair longer than shoulder length should besecured close to the head, or a bathing cap should be worn.Do not operate the spa if the suction cover is broken ormissing. Contact your Dealer for replacement cover if brokenor missing.The wet surface of the spa is slippery. Use care whenentering and exiting.DANGER — Risk of child drowning: Do not permit childrento use this product unless they are closely supervised. The useof a locked cover is highly recommended to prevent unat-tended access.DANGER — RISK OF ELECTRICAL SHOCK: When install-ing and operating this electrical equipment, basic safety pre-cautions should always be adhered to including the following.Warning: A wire connector is provided at the electrical cabineton this spa to connect a minimum No. 8 AWG (8.4 MM2) solidcopper conductor between this spa and any metal equipment,metal enclosures of electrical equipment, metal water pipe, orconduit within 5 feet (1.5 m) of the spa.Do not use electrically connected devices such as televi-sion, radio, or stereo speakers, lights, cooking devices, ortelephones within 5 feet (1.5 m) of the spa while the spa is beingused. Lighting fixtures must not be located directly above orwithin 5 feet (1.5 m) of the spa. If located within 10 feet (3.0 m)of the spa, they must be on a circuit protected by a GFCI(Ground Fault Interrupter Circuit).All fixed metal objects located within 5 feet of the spa, suchas fence posts, railings, door frames, greenhouse structures,gutters, etc., must be attached to the bonding bar on theoutside of the spa electrical cabinet using #8 solid copper wire.With #8 solid copper wire, bond the spa to the houseelectrical panel or approved local bond.The spa must be installed with adequate access andwater drainage system, refer to Installation Instructions, todrain water away from electrical components.CAUTION: Do not turn power ON to the spa unless it is filledwith water to the normal water level, which is to the water levelindicator mark on the skimmer frame. Activating the spa whenthere is an insufficient amount of water can damage thecirculation pump and may cause a fire.If your spa is installed in a 115VAC, 20 AMP circuit:1. The spa is supplied with a 15 foot line cord whichterminates with an integral GFCI plug. Locate the spa nearenough to a weather protected outlet, but no closer than 10feet. DO NOT USE AN EXTENSION CORD! Using anextension cord is hazardous and will decrease the amount ofpower to the unit, causing slow heating, poor whirlpool perfor-mance, or system malfunction.2. Replace damaged line cord immediately. Do not buryline cord. Connect to a grounded, grounding type receptacleonly.3. Bring the line cord out from under the skirt. Removeskirt screws as required to gain access. Make sure the linecord does not lie across a walkway or in a heavily traveled areawhere it may be a safety hazard or become damaged.4. At initial startup and before each use thereafter withpower ON, push the GFCI test button. The reset button shouldpop out. Push this button in to reset. If the interrupter fails tooperate in this manner, there is a ground current flowing or adevice malfunctioning, indicating the possibility of electricalshock. Turn off power and do not use the spa until thesource of the breakdown has been identified and cor-rected.If your spa is installed in a 230VAC circuit:DANGER — RISK OF ELECTRICAL SHOCKYour spa must be equipped with a GFCI at the MainElectrical Panel. At initial startup and before each usethereafter with power ON, push the GFCI test button. Thereset button should pop out. Push this button in to reset. If theinterrupter fails to operate in this manner, there is a groundcurrent flowing or a device malfunctioning, indicating thepossibility of electrical shock. Turn off power and do not usethe spa until the source of the problem has been identi-fied and corrected.20 AMP RECEPTACLEGFCI |
Related manuals for Jacuzzi Select Series
Jacuzzi J Series Owner's Manual
Jacuzzi LCD Series Owner's Manual
Jacuzzi 200 Series Owner's Manual
Jacuzzi Aero Select Owner's Manual
Jacuzzi J-200 Series Owner's Manual
Jacuzzi J-400 Series Owner's Manual
Jacuzzi SWIMSPA Series Owner's Manual
Jacuzzi J - 400 SERIES J - 460 Owner's Manual
Jacuzzi Platinum Series Owner's Manual
Jacuzzi Platinum Series Owner's Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine