Jacuzzi Select Series Owner's Manual

Contents

OPERATIONOperating InstructionsNow that your spa is in place, you are probably eager to take advantage of its unique designed-in features—especially the famous Jacuzzi® hydromassage performance. Besides being a beautiful addition to your indoor decoror outdoor landscaping, your Jacuzzi Whirlpool Bath spa will provide you with the ultimate in spa pleasure. Familiarizeyourself with the operation of the electronic control panel, as described on page 6 of this manual.WARNING: Do not turn ON power to the spa unless it is filled with water to the normal water level. Refer to waterline indicator mark on skimmer frame. Whenever the power is ON, the system may activate even though nocontrols are operated. If the spa’s motor/pump is actuated when there is not sufficient water in the unit, thecirculation pump and heater could be irreparably damaged. Not heeding this caution will nullify the warranty. Inaddition to damaging the unit, operating the spa with insufficient water could cause a fire.Initial Instructions• Using a garden hose, fill the spa with water to thewater line indicator mark on the skimmer frame. (Re-fer to information on using the Water Rainbow spout ifdesired.)• At the house service panel, turn ON the circuit breakeror switch that controls the electrical service to yourspa. Make sure there is no other appliance on thatcircuit.• Your spa must be installed in an electrical circuitprotected with a ground fault circuit interrupter (GFCI)(refer to Electrical Requirements). At initial start-upand before each use thereafter, with power on, pushthe GFCI test button. The reset button should pop out.Push this button in to reset. If the interrupter fails tooperate in this manner, there is a ground currentflowing or a device malfunctioning, indicating thepossibility of electric shock.DANGER: Turn OFF power and do not use the spauntil the source of the problem has been identifiedand corrected.5