Janam XG200 User Manual

Also see for XG200 Series: User manual

Janam XG200 User Manual Manual pdf 8 page image

Getting Started XG200 User ManualJanam Technologies LLC Version 2, April 2019 Getting Started 2-2Charging the XG200 Rugged Mobile ComputerBATTERY SAFETY GUIDELINESThe XG200 has a user-accessible, rechargeable battery that fits into the handle of the computer.Replace only with a Janam-approved battery. There is the risk of explosion if the battery is replacedby an incorrect type. For more information on battery replacement see the janam.com website orcontact JanamCare at 866-915-5311. Use only battery chargers approved for the XG200 by Janam.Janam and its affiliates disclaim any liability for damage caused by the use of other chargers orbatteries. Observe the following guidelines for safe use of Li-Ion batteries:1. Do not expose the battery to excessive heat or cold. Do not short-circuit. Do not incinerate.2. To avoid risk of fire, burn or damage to your battery, do not allow a metal object to touchbattery contacts.3. Do not disassemble the battery. There are no user serviceable parts inside.4. If battery leakage is observed, avoid any contact with affected area and properly disposeof the battery.5. If you come in contact with battery leakage, rinse exposed area with soap and water.If it contacts the eye, flush the eye with water for 15 minutes and seek medical attention.6. Dispose of used battery promptly. Keep away from children. Do not disassemble ordispose of in fire.7. When discarding a battery, contact your local waste disposal provider to understandlocal restrictions for disposal or recycling of batteries.BATTERY CHARGER SAFETY GUIDELINES1. Do not use the equipment in or near areas in which sparks are likely or possible.2. Do not let equipment’s metal contacts and electrical sockets come in contact with metal objects.3. For indoor use only. Do not expose the equipment to rain or any liquids.4. Do not use or store the equipment in direct sunlight or in areas that are prone to get hotsuch as in a parked vehicle, near a heat duct or close to other heat sources.5. Keep equipment’s metal contacts and electrical sockets free from debris that couldobstruct charging or could cause a short circuit.