Jandy HHPlus Series Installation And Operation Manual

Contents

Jandy HHPlus Series Installation And Operation Manual Manual pdf 12 page image

Page 12Mounting bracket side of themechanical sealApply silicone sealant aroundoutside edgeFigure 6. Mechanical Seal ReplacementFigure 7. Mechanical Seal Replacement9.4 Mechanical Seal Replacement1. Follow steps 1-7 of section 9.2, "Removing theImpeller."2. Remove the ceramic seal from the impeller first,by prying between the ceramic and the rubbergasket working in a circle, then remove therubber seal. Do not pry between the rubber andthe plastic impeller, as this will damage theimpeller (See Fig. 5).3. Lubricate (water) the perimeter of the new sealsrubber gasket.4. Press the new ceramic seal and rubber gasketassembly onto the impeller.5. Use Windex or alcohol to remove anyfingerprints from the ceramic seal.6. Using a hammer, tap the old metal w/spring sealout of the mounting bracket from the back side.7. Clean any silicone residue from the mountingbracket where the seal was removed.8. Apply new silicone sealant to the perimeter ofthe new seal and press it into the mountingbracket by hand (See Fig. 6).9. Follow steps 1 thru 15 of section 9.3, "Replacingthe Impeller."Rubber GasketCeramic SealPry here, in-between rubber andceramicImpeller side of themechanical sealFigure 5. Mechanical Seal ReplacementFigure 4. Mechanical Seal ReplacementMounting BracketDiffuser Screws (3)DiffuserImpellerMechanical SealDiffuser O-RingPump BodyO-RingMountingBracketMechanical Seal(Shown not installed)ImpellerDiffuser