Jandy HHPlus Series Installation And Operation Manual

Contents

Jandy HHPlus Series Installation And Operation Manual Manual pdf 13 page image

Page 13Jandy® Pumps9.5 Motor Replacement1. Have a qualified service technician or electricianproperly disconnect the electrical wiring at thepump motor.2. Follow steps 1-7 of section 9.2, "Removing theImpeller."3. Remove the four (4) bolts holding the mountingbracket to the motor. Before removing thebracket, note the alignment of the mountingbracket to the motor (See Fig. 3).4. Replace the motor with an identical make andmodel.5. Replace the four (4) bolts holding the mountingbracket to the motor.6. Follow steps 1 thru 15 of section 9.3, "Replacingthe Impeller."7. Have a qualified service technician or electricianproperly connect the electrical wiring at thepump motor.Note: It is recommended that the mechanical seals bereplaced at the same time the motor is replaced.Figure 8. Mounting Bracket AssemblyBolts & Washers (4)Mounting BracketMotor