Jandy VS FloPro Series Installation And Operation Manual
Also see for Jandy Pro Series: ManualInstallation and operation manualOwner's manualInstallation manualInstallation and operation
                                                                        | |
Contents
| 
Page 9ENGLISHJandy® Pro Series VS FloPro™ Series Variable-Speed Pump | Installation & Operation ManualIt is the responsibility of the electrical installer to providedata plate operating voltage to the pump by ensuringproper circuit sizes and wire sizes for this specificapplication.The National Electrical Code® (NEC®, NFPA-70)requires all pool pump circuits be protected with aGround Fault Interrupter (GFCI). Therefore, it is alsothe responsibility of the electrical installer to ensure thatthe pump circuit is in compliance with this and all otherapplicable requirements of the National Electrical Code(NEC) and any other applicable installation codes.CAUTIONFailure to provide data plate voltage (within 10%)during operation will cause the motor to overheat andvoid the warranty.Bonding and Grounding1. In addition to being properly grounded as describedin Electrical Wiring section, and in accordance withthe requirements of the National Electrical Code(NEC), or in Canada the Canadian Electrical Code(CEC), the pump motor must be bonded to all metalparts of the swimming pool, spa or hot tub structureand to all electrical components and equipmentassociated with the pool/spa water circulationsystem.2. The bonding must be accomplished by using a solidcopper conductor, No. 8 AWG or larger. In CanadaNo. 6 AWG or larger must be used. Bond the motorusing the external bonding lug provided on themotor frame.WARNINGAlways disconnect the power source before workingon a motor or its connected load.WARNINGMake sure that the control switch, time clock, orcontrol system is installed in an accessible location,so that in the event of an equipment failure or a looseplumbing fitting, the equipment can be turned off.This location must not be in the same area as thepool pump, filter, and other equipment.CAUTIONThe pump must be permanently connected to adedicated electrical circuit. No other equipment,lights, appliances, or outlets may be connected to thepump circuit, with the exception of devices that maybe required to operate simultaneously with the pump,such as a chlorinating device or heater.Table 2. VS FloPro dimensionsBase ConfigurationSuctionSideHeightPumpHeight1. Pump without Base 7 3/4”(197 mm)12 3/4”(44 mm)2. Pump with Base 9"(229 mm)14"(356 mm)3. Pump with Base andSpacers9 1/4”235 mm)14 1/4”(362 mm)4. Pump with Small + LargeBase10 7/8”276 mm)15 7/8”(403 mm)Install Spacers into Small Base1. Using a hand cutter tool, cut the plastic barsconnecting the top and bottom sets of spacers, asshown in Figure 4.2. Push the two (2) top spacers and two (2) bottomspacers out of the base.3. Align the pins in the four (4) spacers with the holesin the base and snap the spacers into place, asshown in Figure 5.XXCutspacersat X.Figure 4. Cut Sets of Spacers Out of BaseFigure 5. Snap Spacers into Place3.2 Electrical InstallationVoltage ChecksThe correct voltage, as specified on the pump data plate andTable 3 on page 10 is necessary for proper performance andlong motor life. Incorrect voltage will decrease the pump’sability to perform and could cause overheating, reduce themotor life, and result in higher electric bills. |
Related manuals for Jandy Jandy Pro Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine