Jandy WaterColors LED Installation Manual

Also see for WaterColors LED: Installation guide

Contents

Jandy WaterColors LED Installation Manual Manual pdf 12 page image

Page 12Figure 6. Removing the Jandy WaterColors Light Assembly for Light Engine Replacement1POOL WALLPowerCord NichePOOL LIGHTASSEMBLYPILOT SCREWPush up onbottom oflight assembly2PowerCord NicheSPA LIGHTASSEMBLYBondingcableUnscrew pilot screwand pull top of lightassembly away frompool wallBondingcable7. Plug in the quick disconnect wire (white for the7. Plug in the quick disconnect wire (white for the12V and red for the 120V) onto the terminal12V and red for the 120V) onto the terminal(AC1) of the light engine.(AC1) of the light engine.8. Plug in the quick disconnect wire (black for the8. Plug in the quick disconnect wire (black for the12V and blue for the 120V) onto terminal (AC2)12V and blue for the 120V) onto terminal (AC2)of the light engine.of the light engine.b. Large Light Engine (PCB) Replacement (120Vb. Large Light Engine (PCB) Replacement (120Vand 12V)and 12V)1. Remove three (3) nuts and washers.1. Remove three (3) nuts and washers.2. Unplug the quick disconnect terminals from the2. Unplug the quick disconnect terminals from thePCB.PCB.3. Remove the light engine from the light fixture.3. Remove the light engine from the light fixture.4. Place new light engine into the fixture with the4. Place new light engine into the fixture with theorientation shown in Figure 8.orientation shown in Figure 8.5 Secure the new light engine (PCB) with two (2)5 Secure the new light engine (PCB) with two (2)nylon washers and two (2) nuts. Torque tonylon washers and two (2) nuts. Torque to12 in-lbs.12 in-lbs.6. Plug in the white quick disconnect wire onto the6. Plug in the white quick disconnect wire onto theterminal (J2) of the light engine.terminal (J2) of the light engine.7. Plug in black quick disconnect wire onto terminal7. Plug in black quick disconnect wire onto terminal(J6) of the light engine for the 12V models;(J6) of the light engine for the 12V models;or terminal (J3) of the light engine for 120Vor terminal (J3) of the light engine for 120Vmodels.models.8a. For 12V models, place a nylon washer on the8a. For 12V models, place a nylon washer on thestud and place the green ground wire terminal onstud and place the green ground wire terminal onthe nylon washer and secure both with the nut.the nylon washer and secure both with the nut.Torque to 12 in-lbs.Torque to 12 in-lbs.8b. For 120V models, place the green ground wire8b. For 120V models, place the green ground wireon the stud and secure with the nut. Torque to 12on the stud and secure with the nut. Torque to 12in-lbs.in-lbs.6. Reassemble the fixture.a. If not already done, remove the gasket from thea. If not already done, remove the gasket from theglass lens and install a new gasket, P/N R0451101glass lens and install a new gasket, P/N R0451101for the large light and R0400501 for the smallfor the large light and R0400501 for the smalllight, on the lens. On the small light, remove thelight, on the lens. On the small light, remove thediverger from the lens.diverger from the lens.NOTE A new lens gasket must be used each time thelight is reassembled.