Jandy WaterColors LED Installation Manual

Also see for WaterColors LED: Installation guide

Contents

Jandy WaterColors LED Installation Manual Manual pdf 14 page image

Page 147. Reinstall the Jandy Light into niche fixture.a. Coil the extra four (4) feet of cord around thea. Coil the extra four (4) feet of cord around thefixture or into the base of the niche and place thefixture or into the base of the niche and place thelight assembly into the niche.light assembly into the niche.b. Engage the retainer tab on the bottom of the faceb. Engage the retainer tab on the bottom of the facering, then pivot the top of the fixture inward andring, then pivot the top of the fixture inward andtighten the special pilot screw.tighten the special pilot screw.WARNINGUse only the special pilot screw provided with thisunderwater light. This screw mounts and electricallygrounds the housing securely to the mounting ringand wet niche. Failure to use the screw providedcould create an electrical hazard, which could resultin death or serious injury to pool or spa users,installers or others due to electrical shock.8. If pool is empty, fill the pool until the underwaterlight is completely submerged in water beforeoperating the light for more than 10 seconds. Turnon main switch or circuit breaker, as well as theswitch, which specifically operates the underwaterlight, to check for proper operation.WARNINGNever operate this underwater light for more than10 seconds unless it is totally submerged in water.Without total submersion, the light assembly will getextremely hot, which may result in serious burns or indamage to the light. This may result in serious injuryto pool or spa users, installers, or bystanders or indamage to property.Section 8. Twelve (12) VoltInstallationA separate 12-Volt AC Transformer is required on all12-Volt Models. For Jandy WaterColors Light use a150-watt multi-tap 12-volt system per light.NOTE For optimum performance Jandy recommendsto use one transformer per 12-volt light.To ensure maximum safety, it is strongly recommendedthat a transformer that has been listed or recognized bya Nationally Recognized Testing Laboratory (NRTL) forthe application be used.Figure 9. Alignment of the Lens, Face Ring, Housing and Clamps for WaterColors LightsAlign arrow of thelens with the pilotscrewAlign pilot screw withthe arrow located onthe fixture labelFigure 10. Cross Section of Jandy WaterColors LEDLightThick moldedside of thegasket mustmate withthe body ofthe housing