Jenn-Air 30" (76.2 CM) Installation Instructions Manual

Also see for JDRP430WP: Design and planning guide Use and care guide Manual Installation instructions

14Level RangeNOTE: Range must be level for satisfactory baking performance.1. Place rack in oven.2. Place level on rack and check levelness of the range, firstside to side; then front to back.3. If range is not level, adjust the leveling rods. Turn levelingrods located behind the kick plate to level range and to raiseor lower range to the desired countertop height.NOTE: All roller feet must be off the floor upon final installation.Install Griddle(on griddle models)The griddle is factory installed.1. Place drip tray in the well at the front of the griddle. Slide traytoward the back until it stops.2. Clean griddle before using. Refer to the Use and Care Guide.Electronic Ignition SystemInstall Burner Bases and Burner CapsInstall the burner base, making sure the igniter electrode isproperly aligned with the base. Place burner caps on top ofburner bases. If burner caps are not properly positioned, surfaceburners will not light.Initial Lighting and Gas Flame AdjustmentsCooktop burners use electronic igniters in place of standingpilots. When the cooktop control knob is turned to any position,the system creates a spark to light the burner. This sparkingcontinues until the flame is lit or the knob is turned to Off.Check Operation of Cooktop BurnersPush in and turn each control knob to the “LITE” position.The surface burners and grill flames should light within4 seconds. The first time a burner is lit, it may take longer than4 seconds to light because of air in the gas line.After verifying the proper burner operation, turn the control knobsto OFF.If burners do not light properly:■ Turn cooktop control knob to the “OFF” position.■ Check that the range is plugged in and the circuit breaker hasnot tripped or the fuse has not blown.■ Check that the gas shutoff valves are set to the “open”position.■ Check that burner caps are properly positioned on burnerbases.Repeat start-up. If a burner does not light at this point, contactyour dealer or authorized service company for assistance.A. Front leveling rodB. Rear leveling rodA. Griddle drip trayB. GriddleAABBAB20,000 Btu/h Ultra Power™ Dual-FlameBurnerA. IncorrectB. Correct15,000 Btu/h Professional BurnerA. IncorrectB. Correct5,000 Btu/h Simmer/Melt BurnerA. IncorrectB. CorrectABABAB