Jenn-Air 30" Installation Instructions And Use & Care Manual

Also see for 30": Installation instructions Use and care guide Use & care guide Installation Instructions and Use & Care Guide Installation Instructions and Use & Care Guide

Jenn-Air 30" Installation Instructions And Use & Care Manual Manual pdf 12 page image

12TimerThe range hood can be set to turn off automatically after15 minutes.1. Press and hold the desired fan speed button for 2 seconds.The fan will run on the chosen speed for 15 minutes and thefan speed button light will flash continuously.After 15 minutes, the fan will turn Off automatically.2. Press the desired fan speed button again while the fan timeris running to cancel the fan timer.NOTE: Changing the fan speed or turning Auto Sense On willalso cancel the 15-minute timer.LightThe range hood has both task and ambient lighting.To operate the lights:1. Touch LIGHT once to turn the LED task lights On.2. Touch LIGHT again to turn LED task lights Off. The ambientlights will turn On.3. Touch LIGHT a third time to turn the ambient lights Off.NOTE: To turn both the task and ambient lights on at the sametime, touch and hold LIGHT for 2 seconds. Touch LIGHT again toturn the task and ambient lights Off.RANGE HOOD CARECleaningIMPORTANT: Clean the hood and grease filters frequentlyaccording to the following instructions. Replace grease filtersbefore operating hood.Exterior Surfaces:To avoid damage to the exterior surface, do not use steel wool orsoap-filled scouring pads.Always wipe dry to avoid water marks.Cleaning Method:■ Liquid detergent soap and water, or all-purpose cleanser■ Wipe with damp soft cloth or nonabrasive sponge, and thenrinse with clean water and wipe dry.Metal Grease Filter1. Open the stainless steel panel. Grasp panel at the frontcorners and pull down to disengage the 2 catch pins from thespring catches. The panel is attached at the rear and willrotate down.2. Remove each filter by pulling the spring release handle andthen pulling down the filter.3. Wash metal filters as needed in dishwasher or hot detergentsolution.4. Reinstall the filter by making sure the spring release handlesare toward the front. Insert aluminum filter into upper track.5. Push in spring release handle.6. Push up on metal filter and release handle to latch into place.7. Repeat steps 1 - 5 for the other filter.8. Close the stainless steel panel. Engage the (2) pins in thespring catches to secure.Non-Vented (Recirculating) Installation FiltersThe charcoal filter is not washable. It should last up to 6 monthswith normal use. Replace with Charcoal Filter Kit. See the“Accessories” section for information on ordering.To replace charcoal filter:1. Remove metal grease filter from range hood. See “MetalGrease Filter” in this section.2. Bend spring clips away from metal grease filter.3. Place charcoal filter into top side of metal filter.A. Metal filtersB. Stainless steel panelC. Catch pins (2)D. Spring catches (2)CDABA. Spring release handleA