Jenn-Air 30" Installation Instructions And Use & Care Manual

Also see for 30": Installation instructions Use and care guide Use & care guide Installation Instructions and Use & Care Guide Installation Instructions and Use & Care Guide

Jenn-Air 30" Installation Instructions And Use & Care Manual Manual pdf 9 page image

9Make Electrical Connection1. Disconnect power.2. Remove terminal box cover.3. Remove the knockout in the terminal box and install a ULlisted or CSA approved ¹⁄₂" (12.7 mm) strain relief.4. Run home power supply cable through strain relief, intoterminal box.5. Use UL listed wire connectors and connect black wires (C)together.6. Use UL listed wire connectors and connect white wires (E)together.7. Connect green (or bare) ground wire from home power supplyto yellow-green ground wire (F) in terminal box using UL listedwire connectors.8. Tighten strain relief screw.9. Install terminal box cover.10. Check that all light bulbs are secure in their sockets.11. Reconnect power.Optional Power Cord Kit InstallationsFor optional power cord kit installations, follow the instructionssupplied with the power cord kit. See the “Assistance or Service”section for information on ordering.NOTE: Use only with range hood cord connection kits that havebeen investigated and found acceptable for use with this modelrange hood.A. KnockoutB. Terminal box coverC. Terminal box screws (7)A. Home power supply cableB. UL listed or CSA approved strain reliefC. Black wiresD. UL listed wire connectorsE. White wiresF. Green (or bare) and yellow-green ground wiresWARNINGElectrical Shock HazardDisconnect power before servicing.Replace all parts and panels before operating.Failure to do so can result in death or electrical shock.A BCCCCABCDEFWARNINGElectrical Shock HazardElectrically ground blower.Connect ground wire to green and yellow ground wirein terminal box.Failure to do so can result in death or electrical shock.