Jenn-Air 30" WALL-MOUNT CANOPY RANGE HOOD Installation Instructions And Use & Care Manual

Also see for 30" WALL-MOUNT CANOPY RANGE HOOD: Installation Instructions and Use & Care Guide Installation Instructions and Use & Care Guide Installation & use manual Installation Instructions and Use & Care Guide

Jenn-Air 30" WALL-MOUNT CANOPY RANGE HOOD Installation Instructions And Use & Care Manual Manual pdf 8 page image

88. Place the support bracket on the template aligning it with thetraced rectangle. Mark centers of 4 fastener locations throughthe template to the wall, 2 for support bracket, 2 for bottomrear of blower housing.IMPORTANT: All screws must be installed into wood.Remove the template.9. Drill ⁷⁄₆₄" (2.75 mm) pilot holes at all locations where screwsare being installed into wood.NOTE: When mounting into a concrete wall, drill ⁵⁄₁₆" (8 mm)pilot holes and use anchors supplied.10. Attach the support bracket to the wall using 2 - 5 x 45 mmscrews at the top 2 drilled hole locations.Vent Cover Bracket Assembly and Installation1. Assemble the 3 pieces of the vent cover bracket using 4 -4 x 8 mm screws provided. The assembled bracket should besized to dimension "X" to fit inside the upper vent cover.2. Install vent cover bracket to wall about ¹⁄₈" (3.0 mm) awayfrom the ceiling. Use 2 - 5 x 45 mm screws with 8 x 40 mmdrywall anchors supplied.Complete Preparation1. Determine and make all necessary cuts in the wall for the ventsystem. Install the vent system before installing the hood. See“Venting Requirements” section.2. Determine the required height for the home power supplycable and drill a 1¼" (3.2 cm) hole at this location.3. Run wire through the home power supply cable according tothe National Electrical Code or CSA Standards and localcodes and ordinances. There must be enough ½" conduitand wires from the fused disconnect (or circuit breaker) boxto make the connection in the hood’s electrical terminal box.NOTE: Do not reconnect power until installation is complete.4. Use caulk to seal all openings.Install Range Hood1. Using 2 or more people, hang blower housing on lowersupport bracket using the 2 mounting hooks on the rear ofthe blower housing.2. Level the blower housing with leveling screws in mountinghooks, using a level across bottom of blower housing.A. CenterlineB. Lower support bracketC. 5 x 45 mm screwsD. Mounting height referenceE. Fastener locationsF. WallA. Support bracketB. 5 x 45 mm screwsC. Centerline on wallA. Vent cover bracket assemblyB. Upper vent coverC. 4 x 8 mm screwsABCDEFBCA. Vent cover bracketB. Centerline on wallA. Lower support bracketB. Mounting hooksC. Adjust in and out(for leveling front to back).D. Adjust up and down(for leveling left to right).E. Blower housing