Jenn-Air C 2300279C Use And Care Manual

Jenn-Air C 2300279C Use And Care Manual Manual pdf 8 page image

8Base GrilleRemove the Base Grille1. Open the refrigerator door.2. Using a Phillips screwdriver, remove the two screws. Pushboth tabs in toward the center to release the base grille fromthe refrigerator.3. Remove the base grille.Replace the Base Grille1. Open the refrigerator door.2. Position the base grille so that both tabs align and the basegrille snaps into place. Replace the two screws. Tighten thescrews.REFRIGERATOR USENormal SoundsYour new refrigerator may make sounds that your old one didn’tmake. Because the sounds are new to you, you might beconcerned about them. Most of the new sounds are normal. Hardsurfaces, such as the flooring and surrounding structures, canmake the sounds seem louder. The following describes the kindsof sounds and what may be making them.■ Your refrigerator is designed to run more efficiently to keepyour food items at the desired temperatures and to minimizeenergy usage. The high efficiency compressor and fans maycause your refrigerator to run longer than your old one. Youmay also hear a pulsating or high-pitched sound from thecompressor or fans adjusting to optimize performance.■ Rattling noises may come from the flow of refrigerant or itemsstored inside the refrigerator.■ As each cycle ends, you may hear a gurgling sound due to therefrigerant flowing in your refrigerator.■ You may hear water running into the drain pan when therefrigerator is defrosting.■ You may hear clicking sounds when the refrigerator starts orstops running.Using the ControlFor your convenience, your refrigerator control is preset at thefactory. When you first install your refrigerator, make sure that thecontrol is still preset to the mid-setting as shown.Adjusting ControlsThe mid-setting indicated in the previous section should becorrect for normal usage. The control is set correctly whenbeverages are as cold as you like.If you need to adjust the temperature, wait at least 24 hoursbetween adjustments and then recheck the temperature.To make the refrigerator colder, adjust the control to the nexthigher setting. To make the refrigerator less cold, adjust thecontrol to the next lower setting.REFRIGERATOR FEATURESRefrigerator ShelvesYour model may have glass or wire shelves. Store similar foodstogether and adjust the shelves to fit different heights. Thisreduces the time the refrigerator door is open and saves energy.To Remove and Replace Shelves:1. Remove the shelf by lifting it up and out of the shelf brackets.Remove the shelf.2. Replace the shelf by inserting it into the shelf brackets.NOTE: Be sure the shelf is level.Lower ShelfTo Remove and Replace Lower Shelf:1. Remove the shelf by lifting it up and pulling it forward.2. Replace the shelf by lowering it on the guides.A. TabsB. ScrewsBA AImportant information to know about glass shelvesand covers:Do not clean glass shelves or covers with warm water whenthey are cold. Shelves and covers may break if exposed tosudden temperature changes or impact, such as bumping.Tempered glass is designed to shatter into many small,pebble-size pieces. This is normal. Glass shelves and coversare heavy. Use both hands when removing them to avoiddropping.