5INSTALLATION REQUIREMENTSTools and PartsTOOLS NEEDED:Gather the required tools and parts before starting installation.Read and follow the instructions provided with any tools listedhere.Additional Tools Needed (Style 2 - Overlay only):PARTS NEEDED (Style 2 - Overlay only):PARTS SUPPLIED:Location RequirementsNOTES:■ For the refrigerator drawers to be flush with the front of thebase cabinets remove any baseboards or moldings from therear of the opening. See “Product Dimensions” and later inthis section “Opening Dimensions (both styles).”■ It is recommended that you do not install the refrigeratordrawers near an oven, radiator, or other heat source.■ Do not install in a location where the temperature will fallbelow 55°F (13°C).Opening Dimensions (both styles)■ Height dimensions are shown with the leveling legs extendedto the minimum height of ¹⁄₄" (6.35 mm) below the refrigeratordrawers.NOTE: When leveling legs are fully extended to 1" (25 mm)below the refrigerator drawers, add ³⁄₄" (19.05 mm) to theheight dimensions. See “Product Dimensions.”■ If the floor of the opening is not level with the kitchen floor,shim the opening to make it level with the kitchen floor.Electrical RequirementsBefore you move your refrigerator drawers into the final location, itis important to make sure you have the proper electricalconnection.Recommended grounding methodA 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, groundedelectrical supply is required. It is recommended that a separatecircuit serving only your refrigerator drawers be provided. Use anoutlet that cannot be turned off by a switch. Do not use anextension cord.IMPORTANT: If this product is connected to a GFCI (Ground FaultCircuit Interrupter) equipped outlet, nuisance tripping of the powersupply may occur, resulting in loss of cooling. Food quality andflavor may be affected. If nuisance tripping has occurred, and ifthe condition of the food appears poor, dispose of it.■ Cordless drill■ ¹⁄₈" Drill bit■ Tape measure■ Level■ Phillips screwdriver■ Scissors■ Pencil■ Scribe■ Custom Overlay Drawer Panels —See “Custom Overlay Drawer Panels.”■ Hardware■ Hooks (8)■ Overlay plates (4)■ Screws (16)WARNINGExplosion HazardKeep flammable materials and vapors, such asgasoline, away from refrigerator drawer(s).Failure to do so can result in death, explosion, or fire.Critical Dimensions:A. 14³⁄₄" (37.5 cm) utility openingB. 24" (60.96 cm) minimum opening width¹⁄₂"(1.3 cm)A14³⁄₄"(37.5 cm)24"(60.96 cm)min.24" (60.96 cm) min.34³⁄₈" (87.3 cm) min.35" (88.9 cm) max.BElectrical Shock HazardPlug into a grounded 3 prong outlet.Do not remove ground prong.Do not use an adapter.Do not use an extension cord.Failure to follow these instructions can result in death,fire, or electrical shock.WARNING